1.2 Instalación

The iSG Display can be placed on a desktop using the included stand or mounted on a wall.

Adjust the bracket angle

Adjust the supporting bracket in the package to the angle as shown in the figure below

Place the device on the stand

Attach the magnetic surface of the desktop stand to the metal plate located at the center of the product's back. Ensure that the lower bracket supports the protruding part of the product's lower back. Then, place the product on the desktop at a slight tilt to ensure stability.

Nota: The bottom of the product must be in full contact with the desktop. Do not leave it suspended, as this may cause instability during use. The stand is designed only to provide angled support from the back, not to bear the full weight of the product.

Fix the hanging plate on the wall

The back of the product includes a standard mounting hole, which can be used with a wall-mounted hook or an ordinary nail. When using a regular nail, since there is only a single support point, we recommend applying adhesive to the back of the product for added stability and to prevent shaking during operation.

Hanging plate

For better support, we recommend a three-point mounting setup. While a dedicated mounting bracket is not included with the product, we can provide a 3D printing file so users with the proper resources can print and use a custom bracket.

Haz clic Here to download the 3D printing file for the mounting bracket

Place the device on the bracket

Hang the device on the hanging plate

When using a regular nail, since there is only a single support point, we recommend applying adhesive to the back of the product for added stability and to prevent shaking during operation.